fttttttttt@Pnryef
WtC'
PNIE E l'tO wtodets
NloddlesPwIEEllO
Modetos
PlVlE Al lO
CrstnetJs lVlffi@l
lVlanuel
de t'utilisaEeur
lVlanual del Ltsuario
Welcome
This COLEMAN@ POWERMATE@
product
has been carefully engineered and
manufactured to
give you
dependable operation. Please read this manual
thoroughly before operating
your
new
COLEMAN@
POWERMATE@
product,
as
it contains the information
you
need to become
familiar with its features
and
obtain
the
performance
that will bring
you
continued enjoyment
for many
years.
Please keep this manual on file for future reference.
Warnings:
.When
jumpstarling
your
vehicle, make sure that the Portable Power Source
is
securely connected
to
your
vehicle's 12Volt
power port.
Failure to do so may
result
in
the
improper functioning
of
the unit.
.
Do not expose unit to moisture.
.Always
turn unit off
when not in use.
.
Do not open unit.There are
no
user serviceable
pafts
in this unit. Doing so will
void the warranty.
o
Do not dispose
of
this
product
in fire, batteries
inside
product
may
explode or
leak.
OPERATING
INSTRUCTIONS:
Charging the Unit
Battery
The Portable Power Source
has
a built-in
nickel-cadmium battery. Although the
unit
may
arrive
partially
charged from the
factory. we recommend that
you
fully
charge
it
before
the first use.
Once
your
vehicle is running, simply
plug
the
Portable Power
Source
into the
12V
power port.
Push the ON/OFF switch
to turn the unit OFE
The LED light
marked
"VL"
will illuminate and the
LED marked
'CH"
will illuminate
green
and
start
flashing.
Several
hours of driving time
is required to fully recharge the
unit.
Once
the unit is fully recharged, the
LED marked
'CH"
will stop
flashing.
The unit will
hold
the charge
for several months.
However,
you
should check
the status of the charge
periodically.
To do this, simply
press
the
ON/OFF
button. The LED light
marked "VL"
should
illuminate GREEN.
lf it does not,
recharge the unit as explained above.
To avoid
wasting the
charge,
immediately
press
the ON/OFF button again
to turn the unit OFE
Note: Some
vehicle's 12-volt
power
ports
do
not
operate
unless the
ignition
switch is in the
"accessory"
or
"on" position.
Note: Do not continuously
charge the unit
for more than
36
hours.
To Next Page
Need help?
General