L1
H
L2
A°
Adjust the lenght following the
position of the fixations of the
tractor, then weld the 2 parts
to definitively fix the machine.
Mounting of the reinforcements
- Angle A° upper than 45°
- Lenght L1 as short as possible
- Distance L2 as long as possible (further than the front wheel axle)
- Height H as high as possible
- Check if the tractor is robust sufficiently to
support the weight of
the machine, especially the front part on which the machine is
screwed.
In order to ensure a good mounting of the machine on tractor, the installer
has to mount the provided reinforcements on the machine. Be sure that the
following instructions are absolutely respected :
PL 5001
To Next Page
Loading...