Attachment
wedge
Saw blade
2 screws M8
Maintenance
ANNUAL MAINTENANCE :
Change the oil of the hydraulic circuit. Change the filter cartridge if it is polluted.
Use only one of the recommended oils (see data sheet).
PERIODIC MAINTENANCE DURING THE TRIMMER PERIOD :
- Weekly :
After removing all vegetable debris from the unit, grease the sliding parts of the tubes,
using a brush.
Check the play in the tubes. If it is too large, carry out the necessary adjustments
(see chapter "Adjustments" ).
- After each trimming session :
Clean all vegetable debris of the unit
Check all the blades (see " Blades maintenance" )
Put the protective covers
Blades :
The blades are assembled
on the shaft fixed by 2 screws M8.
(See fig. 1)
Maintenance :
- In order to maintain good trimming quality, blades must be cleaned after each trimming's
day. In order to do this, scrape off the vegetation which has accumulated with a knife.
Sharpen the blade if necessary
Fig. 1
PL 4195
To Next Page
Loading...