College Bed Lofts Storage Drawers

To Next Page

Storage Drawers Assembly Instructions

The drawer pieces include the Base, Front, Back, Left and Right sides.

The Front & Back have the 2x2 support blocks already installed.

Place the Base on a flat surface and position the Front & Back at each end. Place the Right and Left sides

and attach them to the base using 1-1/4” screws following the diagrams below.

Need help?

Do you have a question about the College Bed Lofts Storage Drawers and is the answer not in the manual?

Summary

Position the Base, Front, and Back, then attach Left and Right sides using 1-1/4” screws.

Attach the base to the front component using 2" screws.

Information regarding pre-installed hard floor or felt sliders on the bottom of the base.

General