What to do if the water shortage light is on in my Collezioni Ice Maker?
If the water shortage indicator light is on for your Collezioni Ice Maker, it could be due to a couple of reasons. First, check if there's enough water in the tank; if the water level is too low, refill it and restart the machine by pressing the stop button first, then the start button. Second, the strainer might be blocked. In this case, you should clean the strainer.
Why is the ice full light on my Collezioni PS78143?
If the ice full indicator light is illuminated on your Collezioni Ice Maker, it means there is too much ice. To resolve this, set the unit to the smallest ice cube option.
Why does my Collezioni PS78143 make a buzzing noise?
If the power indicator light is on but the compressor of your Collezioni Ice Maker is buzzing, it indicates that the voltage is lower than required. Stop the ice maker, ensure the voltage is 100, and then restart it.
What to do if both water low and ice full lights are on in my Collezioni Ice Maker?
If both the water low and ice full indicator lights are on simultaneously on your Collezioni Ice Maker, it suggests that the water box cannot tilt, likely because it's blocked by ice cubes. Try the following steps: 1. Remove the ice cubes. 2. If the problem persists, gently turn the water box by hand slightly and then restart the machine. If neither of these solutions works, contact your local dealer.
How to stop ice cubes from fusing together in my Collezioni Ice Maker?
If the ice cubes in your Collezioni Ice Maker are fusing together, it could be due to a couple of reasons: 1. The ice making time is too long. To fix this, stop the machine, reset the ice making time, and restart it after the ice block melts. 2. The water temperature in the inner liner is too low. Replace the water in the inner liner with water that is between 44.6ºF-77ºF (7ºC-25ºC).
What to do if the water low light is on when the tank is full in my Collezioni PS78143 Ice Maker?
If the Water Low light remains on even when the tank of your Collezioni Ice Maker is full, it could be due to: 1. Using distilled, reverse osmosis, or other very pure water. Try adding a pinch of salt to the water to help the sensor detect it, or use less pure water. 2. An air pocket preventing the water from contacting the level sensor. Force some water through the hole at the bottom right of the water tank to push water to the sensor.
Why is there no indicator light on my Collezioni Ice Maker?
If there is no indicator light on the board of your Collezioni Ice Maker, the fuse may have blown. Replace the fuse to resolve this issue.
Initial setup and placement guidelines before starting operation.
Essential steps to ensure electrical safety and proper grounding.
Overview and functionality of the ice maker's control interface.
Technical details and capabilities of the ice maker unit.
General| Brand | Collezioni |
|---|---|
| Model | PS78143 |
| Category | Ice Maker |
| Language | English |
To Next Page
