Alexander Essing
Using for the first time
Care and maintenance
Warranty
Disposal
CE - Declaration of Conformity
Always hold the machine with both hands.
Press the starting lockout button (1). Press the ON/OFF switch (2).
The integrated electronic controls will start up the machine in a controlled fashion. The more pressure
you apply to the ON/OFF switch, the faster the machine will run.
Due to savety reasons, locking of
the ON/OFF button is not possible.
To stop working, release the ON/OFF switch.
Machines with 2-speed gear units have two maximum speeds available (First gear: Slow / Second
gear: Fast). To change from one gear to the other, turn the gear selection lever through 180°.
Always reduce the speed when submerging the mixing tool in the mixing material or lifting it out.
Once the mixing tool is fully submerged, increase the speed again to ensure that the motor is
adequately cooled.
During mixing you should guide the machine around the mixing container. Continue mixing until all
of the mixing material is completed mixed.
After ending place the machine on the guard handle.
Clean the mixing tool after you have finished your mixing work.
ON/OFF switch
Gear selection lever
Before you carry out any operations on the machine, including changing the mixing tool, always pull out the mains
plug first.
Keep the machine and mixing tool clean.
Keep the ventilation slits (5) clean so that the machine can be properly cooled.
The machine is equipped with self-deactivating carbon brushes. This means that the machine will shut itself down once a
certain level of wear is reached. The carbon brushes can be replaced by an authorized customer service center or by the
Collomix Service center.
Have repairs carried out only by an approved workshop or by your Collomix Service.
Only use original Collomix replacement parts.
For the current spare parts list, log into the Internet under: “http://www.collomix.com” and look for “downloads”.
The manufacturer provides a warranty within the framework of his terms and conditions of delivery in accordance with the
requirements of statutory/country-specific provisions.
Should you need to make a claim under the warranty, please provide us with your invoice or delivery note.
On no account will any warranty claims be accepted if any repairs are carried out by third parties. In the event of any
irregularities, please send the machine to us.
The warranty does not apply to damages caused by natural wear, overloading or improper handling.
Complaints can only be accepted if the device is sent to the Collomix Service center undismantled.
The machine, accessories and packaging should be properly recycled and never disposed of with household waste.
All devices which are no longer suitable for use can be taken for recycling to the nearest depot for electrical scrap or
returned to the manufacturer delivery free.
We declare, with sole responsibility, that this product complies with the following standards or normative products:
EN 50144-1, EN 55014-2; EN 61000-3-2, EN 61000-3-3, IEC 60745-1 in accordance with the provisions of directives
2006/95/EEC, 89/336/EEC, 98/37/EC.
Serviceadresses for:
Great Britain: Ireland:
Artex Rawlplug Ltd. TUCKS Ltd.
Northfield Industrial Estate Hume Avenue
Market Deeping Park West Industrial Park
Peterborough PE6 8LB Dublin 12
Subject to change
GBGB
To Next Page
Loading...