Administrator Password
This project is used to set the password of the system
administrator. Please follow the following steps:
1.select the "Administrator Password" project and press the
"Enter" key.
2.when the "Greate New Password" window appears, the
password you want to set in the input can be in English, digits
and symbols within six bytes, and the input is completed by
pressing the "Enter" key.
3.when the "Enter" key is pressed, the "Confirm New
Password" window will appear, and again the password is
entered to confirm the correct password. If the "Invalid
Password" prompt information is presented, a mistake is
entered when the password is confirmed, and reoperation is
required.
4. if you want to change the password of the system
administrator, please run the password settings again
according to the above program.
5.press the "F10" key to save and exit, password settings can
be effective.
User Password
After the administrator password is set up successfully, this
option will appear to set the ordinary user password. Select "User
Password" item and press the "Enter" key. The rest of the steps
are the same as the administrator password settings.
Note: the administrator password and user password: 1.
Supervisor password: can enter and modify the BIOS setup
program. 2. User password: can enter, but has no right to modify
part of BIOS setup program. 3., if you forget to set the BIOS
password, you can clear the CMOS to solve it.
53
ＢＩＯＳ Ｓｅｔｔｉｎｇ
To Next Page
Loading...
