Colours Air Ride System Owner's
Manual
.,.Air
Ride System Maintenance and Air
pressure
CD
T
o
keep your air ride system in optimal working condition,
You
should check the air pressure at least once a
month.
Use the Fox High Pressure Pump, as shown
below.
The pump is used to add and release air pressure from your FLOAT SHOCKS
.,.To
Pressurize Your
Shock:
1. Locate and Remove the air valve cap from the shock
2. Thread the pump's valve chuck onto the shock's air valve until pressure registers on the
pump
gauge. This takes approximately 6
turns-
Do not over-tighten pump on air valve as this will
damage the pump chuck seal.
v
*If the shock has no air pressure,
the
gauge will read
zero.
To Next Page
Loading...