70psi 90psi 110psi 130psi 150psi 170psi 190 psi
210psi
3. Stroke the pump few cycles. The pressure should increase slowly. If pressure
increases rapidly
check to make sure the Pump is properly fitted and tightened on to the air
valve.
4. Pump to the desired pressure setting- Average air pressure range is from 50 to
21
Opsi
You can decrease pressure by pushing the black bleed valve on the shock
pump.
Pushing the bleed valve half way down and holding it there will allow pressure to escape
from
the pump and
shock.
Pushing the bleed valve all the way down and releasing it will allow only a small amount
of
pressure to escape (micro
adjust
)
.
When unthreading the pump from the air valve fitting, the sound of the air loss is from the
pump
hose, not from the
shock.
Q)
Maximum
Air
Pressure
:
300
psi
correct
Air
Pressure
Check the air pressure
gage
-·
>
When you attach the pump to the shock, the hose
Will
need to fill
w1th
a1r.
Th1s Will
result 1n a
lower
pressure registering approximately 3 to 4 psi on the
gauge.
5. Replace the air valve
cap.
To Next Page
Loading...