coltene/whaledent PINDEX

Need help?

Do you have a question about the coltene/whaledent PINDEX and is the answer not in the manual?

Summary

Pre-drilling Instructions

Drilling Pin Holes

Placing Pins and Sleeves

Pindex Die Model Base Fabrication

Troubleshooting, Maintenance and Service

Oiling and Cleaning

Instructions for cleaning and maintaining the Pindex System drilling unit.

Excessive Pressure Required

Guidance on addressing excessive pressure during model drilling.

Drill Replacement

Step-by-step guide for replacing the drill bit on the Pindex unit.

Drilling Depth Adjustment

Light Beam Spotter Adjustment

Unit Does Not Drill Parallel Holes

Does Not Start

Fuse Blows

Electric Motor Stops

Squeal

Accessory Use Directions

Long, Medium, Short Pins and Sleeves

Instructions for using various pin and sleeve types with the Pindex system.

Dual Pins and Sleeves

Detailed steps for fitting dual pins and sleeves into the Pindex model.

Self-Articulating Pins and Sleeves

Guidance on the application of self-articulating pins and sleeves.

Flexible Molds

Information on using flexible molds for die fabrication with Pindex.

Pindex System Handsaw

How to use the Pindex System Handsaw for die separation.

Pindex Laser Retro-fit Kit

Instructions for installing the Pindex Laser Retro-fit Kit.

Accessories

Replacement Parts

Unit Specifications

Environmental Conditions

Specifies environmental parameters for Pindex unit operation.

Transportation and Storage Conditions

Details temperature and humidity ranges for transport and storage.

Operational Ambient Conditions

Defines operating temperature, humidity, and pressure limits.

Product Markings

Highlights safety and compliance markings on the product.

Warnings

Warranty