©2008 by PSiSC
®
Locker Installation Manual
1. Tools Required
Tape Measure
• 4 ft. Level
• Laser Level
• Stud Finder
• Ratchet Bit Driver (Torx drive bits supplied)
• Flat Head Screw Driver
• Phillips Head Screw Driver
• Drill
• Screw Gun
• Rubber Mallet
• Belt Sander
• Circular Saw
• Miter Saw
• Chalk Snap Line
• 1/4” Drill Bits
• 7/32” Drill Bits
• 1/8” Drill Bits
• Cedar Shims
Thank you for choosing Columbia Lockers
®
from PSISC
®
. We appreciate your
business. At PSISC
®
we strive to provide the industry’s best lockers with
comprehensive installation guides.
Report any missing or damaged material on freight bill. Then call our
customer service number below to have material replaced. Failure to comply
with reporting this information may cause additional charges.
If you need assistance, have questions or comments contact our customer
service department at:
Customer Service Department
Columbia Lockers
®
(803) 252-3020
To Next Page
Need help?
General
