On/off
switch
should be
turned on
Unscrew counter clockwise
Your Com Hem outlet may have
any of these two appearances
1. Start by unscrewing the protective sleeve that may be
covering the hole marked DATA in your Com Hem outlet.
2. Connect the modem cable to the jack on the router that
is marked COAX and the other end of the cable to the
DATA jack in the Com Hem socket that sits in the wall
TIP!
Make sure that the copper pin in the two ends of the cable is
straight and centered in the connector so they do not bend when
You tighten them. Also ensure that the contacts are firmly
screwed to both ends.
3. Plug the power cord into the outlet marked POWER
on the router. Plug the other end into an electrical outlet.
The rear of the router also features an on / off switch,
make sure it is turned on. The lights on the front
now starts to flash, which means the router starts up.
To Next Page
Loading...
General