coM.sat IP BASIC - Host Debug Parameters

Manual coM.sat IP Basic
 ! "
#$  % &'%()$$)!
Copyright according DIN 34!
6.27.1.1 Host Debug Parameters

• Debug Enable:%608D048!0 8
&;606%(!"35

• System Debug:%6B48!8C8D000
80!6062!

o ;
 
 6!
 0
 (  3,!9 21:
 .
 <8%6

o %  
 % 
 % !
 .7-#-'.

o /#7. #$
.050!0I

o -. 
 =5
 4."
 40

o . 
 =5
 4."
 40

&;6D08580!DE(  3,!
92:D-. . 
Note: When debugging is enabled, it should at least show an error level can be
selected. If no debug level is selected, the coM.sat IP Basic displays the following error
message: 'Please select debug level'.