coM.sat IP BASIC - Page 96

Manual coM.sat IP Basic
 ! "
#$ * % &'%()$$)!
Copyright according DIN 34!
• Maximum Digits: %060E!0608
.0!60E!060!8$46


• Destination Address: .080!%
2'%%0&;66;
• Name: .06006.08
E6$0''%%02
Notes: The peer-to-peer routing table is used only if the destination port is a SIP trunk.
When an incoming call on the peer to peer is signalled in the coM.sat IP Basic unit, it will be
routed first through the SIP trunk.
Using the coM.sat IP Basic can be made peer-to-peer calls between two clients if:
• &00823
• &005233;05
239.7-8:
• &066523!0;-'.
9.7-088;805;:
• '08239.06;,. I:00
0523.
Using the coM.sat IP Basic cannot be made peer-to-Peer Calls:
• &2066523D523D6800
;-'.
• &266523D20823
• &20523823;
• &20523D665238
23;.