Need help?Do you have a question about the Comanche MC CAMP and is the answer not in the manual?
General| Brand | Comanche |
|---|---|
| Model | MC CAMP |
| Category | Automobile Accessories |
| Language | English |
Disconnect the trailer tent unit from the towing vehicle.
Use the jockey wheel to ensure the trailer tent is level on the ground.
Lower and secure the rear corner steady using the provided handle.
Open the trailer lid by unlocking it with the provided keys.
Lift both support legs clear of the trailer lid.
Connect the support bars securely onto the designated legs.
Raise the trailer lid to a 180-degree angle until it is level with the ground.
Observe the poles and canvas automatically opening as the lid is raised.
For easier access, remove the mattress and bed slats from the trailer.
Take out all three tables stored within the trailer body.
Removing tables reveals available storage; pack items wisely.
Pull the main pole frame out from the lid, leaving the center pole upright.
Extend all three poles outwards until they click, doing this on both sides.
Pull the canvas off the roof so that it hangs freely.
Raise the middle tensioning pole and outer pole to hang the canvas evenly.
Inside the trailer, use Velcro to secure the canvas to the body front and back.
On the outside, pull the canvas over the trailer body and guide as needed.
Secure the front canvas with pegs and attach the draft skirt.
Position the tables inside the trailer according to your requirements.
Hang curtains and position sitting/bedroom cushions for comfort.
To Next Page