ComAp Adoucisseur softeo - Page 40

RI820251 - 04/18 - ind. A
3 9
.Pressure lost or iron in
conditioned water.
A. ron in the water supply pipe.
B. ron mass in the softener.
C. Fouled resin bed.
D. Too much iron in the raw
water.
A. Clean the water supply pipe.
B. Clean valve and add resin cleaning chemical
increase freuency of regeneration.
C. Check backwash brine draw and brine tank refill.
ncrease freuency of regeneration and backwash
time.
D. ron removal euipment is reuired to install
before softening.
.Loss of resin through
drain line.
A. Air in water system.
B. Bottom strainer broken.
C. mproperly sied drain line
control.
A. Assure that well system has proper air eliminator
control.
B. Replace the bottom strainer.
C. Check for proper drain rate.
.Control cycle
continuously.
A. Controller is faulty.
B. Time of regeneration steps
were set to ero
C. Locating signal wiring break
down
D. Foreign material stuck the
driving gear.
A. Replace the controller.
B. Check program setting and reset.
C. Check and connect locating signal wiring.
D. Take out foreign material.
1.Drain flows
continuously.
A. nternal valve leak.
B. When electricity fails to
supply valve stops backwash or
fast rinse position.
C. Control valve is in Backwash
status.
A. Check and repair valve body or replace it.
B. Adjust valve to service position or turn off bypass
valve and restart when electricity supply.
11.alt water in soften
water.
A. Foreign material in injector or
injector fails to work.
B. Brine valve cannot be shutoff.
C. Time of rapid rinse too short.
A. Clean and repair injector.
B. Repair brine valve and clean it.
C. Etend rapid rinse time.
12.nterupted or
irregular brine.
A. Water pressure too low or not
stable.
B. njector is plugged or faulty.
C. Air in resin tank.
D. Floccules in resin tank during
backwash.
A. ncrease water pressure.
B. Clean or replace injector.
C. Check and find the reason.
D. Clean the floccules in resin tank.