- 3 -
Assembly of High Chair
1. Place the seat base upright on the floor. Insert the upper legs into the seat base as
shown in figure 1a and 1b. Note the folding buttons face outward on the upper legs.
2. Press in the height adjustment levers on the seat base and slide it to the top position
on the upper legs as shown in figure 2.
figure 1a
figure 3a figure 3b
figure 4a
figure 4b
figure 5a figure 5b figure 5c
figure 1b figure 2
3. Attach the stabilizer bar assembly to the upper legs by holding down the release/
locking pins, slide the stabilizer bar assembly onto the upper legs until the release/
locking pins snap into place as shown in figure 3a and 3b. (Note: The stabilizer bar
assembly will only fit into the upper legs one way.) The stabilizer bar assembly,
with the wheels, attaches at the front of the high chair.
4. Align the seat back to the seat base as shown in figure 4a. Press
the sides of the seat back in slightly so the seat back will lock
into the slots on the seat base as shown in figure 4b.
5. Pull the seat back up while pulling up on the release lever until
the seat back locks into one of the recline positions as shown in
figures 5a-c.
To Next Page
Loading...