Security Keypad
Quick Start Guide
XFINITY HOME
SECURITY • CONTROL • ENERGY
Device Overview
Getting Started
Powering Up and Pairing
1. Remove the keypad and keypad battery door
from box. (Important: The battery door must
be mounted to wall before you snap keypad to
battery door)
2. Set your touch screen to pairing mode and then
pull the “Remove to Pair” tab to put device into
pairing mode.
3. The keypad should start the joining process
automatically. When the keypad is not joined
to a network, the network indicator will be off.
Once it is joined, the network icon will become
solid anytime that the keypad is awake.
Once the keypad has successfully joined the
network, the pairing LED will turn solid, the
network indicator will turn on, and the touch
screen should indicate that it has paired with
the keypad.
Battery Compartment
Low Battery
Network Indicator
Status LED/Proximity Sensor
Pairing/Tamper Button
To Next Page
Need help?
General
