15
ENGLISH
Part 2: Reserved for the operator
STARTING the MANUAL WASH CYCLE
Press the START key
to start the wash cycle.
The START key turns BLUE
during the entire duration of the wash cycle.
The countdown of the cycle appears on the display in
seconds. Any other alarm messages will be displayed
on the right.
The following phases are performed during a complete
cycle:
° WASH
° PAUSE
° RINSE
° DRAIN
During the cycle you can
display the ACTUAL temperature
by pressing the BACK key.
THERMOSTOP FUNCTION
If the rinsing temperature is not ADEQUATE at the
end of the washing phase, the COUNTDOWN on the
display stops, so as to indicate the intervention of the
thermostop. The washing phase will last for as long as
is necessary to reach the MINIMUM GUARANTEED
RINSE temperature, equal to the value:
T°setpoint – set thermostop value.
Once the set temperature value is reached, the count-
down resumes until the cycle is completed.
Any other messages will be displayed on the right.
The pause to reach the ideal temperature can be pro-
longed to a maximum of 8 minutes.
After this time, the washing and rinsing cycle is com-
pleted and the H1 alarm will appear on the right side
of the display.
During the thermostop you can
display the ACTUAL temperature
by pressing the BACK key.
STARTSTART
2.1.c STARTING the WASH CYCLE
ATTENTION
It is recommended to check the level of detergent
and rinse agent daily.
IMPORTANT
The MANUAL or AUTOMATIC
(by closing the capote) cycle start-up mode must be
changed by an authorised technician.
2.1.e DRAINING WATER FROM THE TANK
2.1.e .1 MACHINE DRAIN
without a DRAIN PUMP (Fig. 8)
The water in the tank can be emptied at any time of
the day depending on the accumulated lth.
Proceed as follows to perform
this operation:
- SWITCH OFF the dishwasher
by pressing the START key for
5 sec.
- OFF appears on
the display.
- Remove the over ow (13),
allowing the water to drain com-
pletely from the tank;
- Extract the tank lter (14) and
clean it.
STARTSTART
Once the wash cycle is com-
pleted, the SET temperatures
appear on the display.
The START key turns STEADY
GREEN (indicating that the
machine is ready for the next
cycle).
At the end of the wash cycle, remove the dish rack
and shake it gently to remove the last drops on the
washed items.
Let the objects dry and remove them from the dish
rack with clean hands.
Set everything on hygienic and stable surfaces.
2) Turn off the machine by
keeping the START
key pressed for 5 sec.
This way, every active cycle
is interrupted de nitely and the machine is set to
OFF.
When switched on again, the LED associated with
the last selected cycle will light up and the display
will indicate the alarm code "A1" that will disappear
when a new cycle begins.
STARTSTART
STARTSTART
2.1.d INTERRUPTING the CYCLE
The wash cycle can be temporarily interrupted in
two ways:
1) F1 appears on the display
when the capote is opened.
When the capote is closed
again, the cycle resumes from where it stopped.
At the end of the cycle, put the lter (14) and the
over ow (13) back into the respective seats.
To Next Page
Loading...
