COMENDA RC07 User Manual

EN
User instructions
PROBLEMS CAUSES SOLUTIONS
The machine fails to
come on.
The machine does not
ll with water
Insucient washing
Insucient rinsing.
Main switch disconnected.
Water cock shut.
Fill pipe lter dirty.
Rinsing nozzles clogged.
Overow pipe incorrectly inserted.
Hood's opened
Washing lter dirty.
Washing nozzles clogged.
Washing rod clogged.
Insufcient or no detergent.
Machine temperature not reached.
Washing conditions insufcient.
Rinsing nozzles clogged.
Boiler clogged with scaling.
Low mains pressure (less than 200
kPa).
Temperature insufcient.
Incorrectly positioned nozzles or
nozzles deformed.
Turn on the switch.
Turn on the cock.
Detach the ll pipe (7 Fig. 6) and clean the lter (5).
Unscrew and clean the nozzles (19 Fig. 8) under running
water.
Make sure that the overow pipe (13 Fig. 8) has been
correctly inserted.
Close the hood
Clean the lter (14 Fig. 8).
Demount and clean the washing nozzles under running
water (19).
Demount and clean the rod (17 Fig. 8).
Top up the detergent in the canister and check its con-
centration.
Wait until the tank water has reached the right tempe-
rature (50°C).
Make sure that the washing phase takes place correctly.
Unscrew the nozzles (18 Fig. 8) and clean them under
running water.
Contact the after-sales service.
Wait until the pressure returns or purchase a pressure
pump.
Contact the after-sales service.
Make sure that the nozzles are in their correct positions.
Replace any damaged ones.
TROUBLESHOOTING
34

COMENDA RC07 Specifications

General

Brand	COMENDA
Model	RC07
Category	Dishwasher
Language	English