Comet H5421 - Restore to Factory Default

IE-HGS-H5(6)4XX-05
17
show value on LCD
don’t show value on LCD
Show CO
2
concentration at LCD display
This item provides to choice if CO
2
value may be displayed at LCD display or not. It is possible
to change it after „SET“ key pressing.
show value on LCD
don’t show value on LCD
Computed value selection
It shows the actually selected computed value name. It is possible to change it after „SET“ key
pressing. There is possible choice one of the following computed values:
dew point temperature
absolute humidity
mixing ratio
specific humidity
specific enthalpy
5.7. Restore to „Factory default“
This item provides regulator restoring to factory setting. Press „SET“ key, select „YES“ and
confirm it by pressing of „SET“ key. It reset regulator parameters to following values:
communication protocol: Modbus RTU
regulator address: 1
communication speed: 9600Bd, no parity, 2 stop bits
value assigned to Relay1 and Relay2: none
password for setting through keys: 0000
display: on