4
Winch & Roller Fairlead Mounting
1. It is very important that the winch shall be
mounted on a flat hard surface in order to make
sure the motor, drum and gearbox housing are
aligned correctly.
2. If a different mounting plate is used, the thickness
shall be 5 mm (3/16”). If different hardware
is used, it must be SAE grade 8 minimum.
3. Four (4) included M8x 25L Grade 8.8 High
Tensile Steel Bolts must be used for
securing the
winch on the mounting plate in order to sustain the loads imposed on the winch mounting.
4. Two (2) included M8 x 20L Grade 8.8 High Tensile Steel Bolts must be
used for
securing the roller fairlead on the mounting plate.
Solenoid Mounting
1. It disconnects your winch from the power source when the vehicles is not in use
2. It should be mounted close to the battery and keep the location from all metal structures.
Remote Socket Mounting
1.Determine the mounting location for the remote socket.
2.Drill three holes on a plate and install.
ATV-3000
UTV-4000
To Next Page
Loading...
