Page 11
NOTE
When the continuous draining feature is not being used,
remove the drain hose from the outlet, and dry the water
in the continuous drain hose outlet.
2. Continuous draining
• Water can be automatically emptied into a floor drain
by attaching the unit with a water hose (Id
Ø 5/16”,
not included) with a female threaded end (ID: M = 1”,
not included).
• Remove the plastic cover from the back drain outlet
of the unit and set aside, then insert the drain hose
through the drain outlet of the unit and lead the
drain hose to the floor drain or a suitable drainage
facility. (See Fig. 9 and Fig. 10)
• When you remove the plastic cover, if there is some
water in the back drain outlet of the unit you must
dry it. Make sure the hose is secure so there are
no leaks and the end of the hose is level or sloping
downwards to let the water flow.
• Direct the hose toward the drain, making sure that
there are no kinks that will stop the water flowing.
• Select the desired humidity setting and fan speed on
the unit for continuous draining to start.
Fig. 10
Fig. 9
Remove the
plastic cover
rotating counter-clockwise
Drain hose
Operating
Instructions
To Next Page
Loading...
Need help?
General
