Comfee CDC17P0AWW - Quick Start Guide; Connecting to Power Supply; Adding Water to the Tank

or
2
1
Water Inlet
Drain Pipe
QUICK START GUIDE
Please read the corresponding content for detailed operating method.
Connecting to Power Supply
The clamp must be tightened by a screwdriver.
Fix the drain pipe with
suction cups
The power supply is 120VAC 60Hz
The specification of the socket is 10A 120VAC
The connection of the drain pipe: Put end of the drain into a sink or bucket.
Adding Water to the Tank
There are two ways to keep the tank filled.
1. Before starting:
When the tank is full of water, the machine will
beep fleetly for 3 seconds.
2. After starting:
Water is not enough, light is on;
Water is enough, light will be off and the machine will
beep fleetly for 3 seconds.
There are two ways to add water into the tank:
1
2
Connect inlet hose to the tap
Open the cap and slowly add water into the dishwashers
tank manually
Note:Before adding water, you need to press the power
button to turn on the diswasher
Or
33
ubber
1 2