26
Connect the inlet pipe to the dishwasher
WARNING
Please keep the soft cover on the suction hose after you connect the
inlet pipe to the dishwasher. A little water will flow out if the
soft cover is pulled out
2. Connect the suction pipe and add water into the
suction bucket
1 2
2
.Connect suction pipe .Connect the suction pipe to the bucket
or
V≥12L
(3.17 Gal)
WARNING
Please make sure Bucket is filled up over 12L(3.17 Gal)-tick mark.Otherwise
the dishwasher may show E1 code on the screen due to insufficient
supply water,and it will work properly not