Why is my COMFORTPOOL EasyHeat Heat Pump not running?
If your COMFORTPOOL Heat Pump isn't running, first, ensure it's receiving power by checking the cable and circuit breaker connections. If the water temperature has reached the set value, the heat pump might be in a constant temperature state, so verify the water temperature setting. Also, if the heat pump has just started, it may take a few minutes to restart.
What to do if my COMFORTPOOL Heat Pump has a short running time?
If the COMFORTPOOL Heat Pump is running for only a short time, check that the fan is working. If the fan is not running, contact your dealer to check and, if necessary, replace the cable connections between the motor and fan. Insufficient air ventilation could also be the cause, so check the location of the heat pump unit and remove any obstacles to ensure good air ventilation. Finally, insufficient refrigerant may be the problem, in which case you should contact your dealer for possible repair or replacement of the heat pump unit.
What causes compressor discharge over high temperature protection in COMFORTPOOL EasyHeat Heat Pump?
Compressor discharge over high temperature protection can be caused by a blocked capillary tube, insufficient refrigerant, or no water flow in the heat exchanger. Contact your dealer, as it must be repaired by a professional technician.
What causes low pressure protection in COMFORTPOOL Heat Pump?
Low pressure protection in your COMFORTPOOL Heat Pump can be due to a disconnected or failed low-pressure switch, or gas leakage. Contact your dealer, as it must be repaired by a professional technician.
Why does my COMFORTPOOL EasyHeat Heat Pump have water stains?
Water stains on your COMFORTPOOL Heat Pump can be due to condensation, which requires no action. If it's due to water leakage, contact your dealer to have the titanium heat exchanger checked for defects.
How to fix too low or too high ambient temperature protection on COMFORTPOOL Heat Pump?
Too low or too high ambient temperature protection in COMFORTPOOL Heat Pump may be triggered if the ambient temperature is outside the operating range of 11°C - 42°C. Wait for the ambient temperature to rise to 13°C or cool down to 40°C to restart. Alternatively, it could be due to controller failure, in which case you should contact your dealer for a possible controller replacement.
What to do if water temperature sensor failure occurs in COMFORTPOOL EasyHeat?
Water temperature sensor failure in your COMFORTPOOL Heat Pump is caused by an open or short circuit in the water temperature sensor. Contact your dealer for a possible water temperature sensor replacement (5K).
What causes ambient temperature sensor failure in COMFORTPOOL EasyHeat Heat Pump?
Ambient temperature sensor failure in your COMFORTPOOL Heat Pump is caused by an open or short circuit in the ambient temperature sensor. Contact your dealer for a possible ambient temperature sensor replacement (5K).
How to resolve high temperature protection sensor failure in COMFORTPOOL Heat Pump?
High temperature protection sensor failure in your COMFORTPOOL Heat Pump is caused by an open or short circuit in the high temperature protection sensor. Contact your dealer for a possible high temperature protection sensor replacement (50K).
What to do if my COMFORTPOOL EasyHeat Heat Pump shows low pressure protection?
If your COMFORTPOOL Heat Pump displays a low pressure protection error, it could be due to a disconnected or faulty low-pressure switch, or a gas leak. In either case, contact a dealer; repairs must be performed by professional technicians.
General| Brand | COMFORTPOOL |
|---|---|
| Model | EasyHeat Series |
| Category | Heat Pump |
| Language | English |
To Next Page