4. Battery and Charger
15
- The charging port is under the left pedal of the MS|3000 body, and
the charging port cover is opened and the charging interface is dry.
(Picture 13)
- Please insert the positioning groove of the charging port of the char-
ger at the charging port of the car body first, and then connect the
charger plug to the ac power socket. After charging, unplug the AC
power supply, and then unplug the connector that is connected to the
charging port of the car.
- In order to ensure the safety of transportation, the MS|3000 battery
pack is not fully charged. Due to the self-consumption of electricity
during the transportation and storage cycle, it may cause low or no
power when first used. This is normal. Don't worry. Charge according
to the charging method.
- Please use the MS|3000 original charger for charging. Do not use
other chargers for charging. The company will not be responsible for
any consequences caused by not using the original charger.
- The MS|3000 charging time takes about 5 - 8 hours (depending on
the battery pack capacity). When charging, the indicator light on the
charger lights up red, indicating that the power is on and charging.
When the indicator changes from red to green, the battery is fully
charged. Stop charging at this time. The maximum charging time
should not exceed 10 hours. Long-term charging will affect the life and
safety of the battery pack.
- It is forbidden to disassemble the charger, As it has a high voltage
circuit.
- Do not connect the charger to the AC power supply without the char-
ger working, otherwise, it will damage the life of the charger and may
cause other dangers. When charging, the surrounding environment
should beer^.ply, ventilated, no fire, no flammable or explosive materi-
als around, and do not cover anything on the charger. Pay attention to
prevent liquid and metal particles from entering into the charger, pre-
vent falling and impact, so as to avoid damage
To Next Page
Loading...