Command Start CS-396i User Manual

4-BUTTON
AUTOMATIC / MANUAL TRANSMISSION
REMOTE STARTER
DOC. 1.00 - 1W-AM-4B-A-M - - September 12, 2007 - - MO - Assembled in Canada
CS-396i
User Guide
WARNING
It is the responsibility of the vehicle operator to ensure their vehicle is
parked in a safe and responsible manner.
1. a) Manual transmission
: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL position
and the parking brake is engaged in order to avoid accidents upon remote
starting.
b) Automatic transmission
: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in “Park” in order to avoid
accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled or
put into valet mode before servicing.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment.

Command Start CS-396i Specifications

General

Type	Remote Starter
Range	Up to 1, 500 feet
Channels	2
Keyless Entry	Yes
Car Compatibility	Most vehicles with automatic transmission
Model	CS-396i
Brand	Command Start
Security Features	Anti-theft system

Summary

Introduction

Basic Remote Operation

Vehicle Presets

Heater and Heated Seat

Recommended accessory settings for remote start, such as fan and heated seats, should be set to low or medium.

Windshield Wipers, Radio and Headlights

Ensure windshield wipers, radio, and headlight switches are off before remote starting to prevent battery drain.

Arming the Starter Kill

Remote Starting Your Vehicle

Setting Your Vehicle into Ready Mode

Driving Off

Remote Starter Features

Idle Mode

Allows the engine to run and doors to remain locked for short stops without the key in the ignition.

Valet Modes

Valet Mode using the Valet Button

Procedure to enable or disable Valet Mode using the dedicated Valet Button.

Ignition Valet

Method to enter/exit Valet Mode by cycling the ignition key 5 times.

Panic Mode

Cold Weather Mode

Advanced Features: Installation-programmable Options

Remote Door Locks

Provides keyless entry functionality, allowing remote locking and unlocking of vehicle doors.

Priority Door Access

Unlocks the driver's door with one press, and all other doors with a second press of the UNLOCK button.

Ignition-controlled Door Locks Option

Automatically locks doors when the ignition is turned ON and unlocks when turned OFF.

Secure Lock Option

Relocks doors automatically after remote start to maintain vehicle security.

Remote Trunk Release Option

Allows opening the vehicle's trunk remotely using the transmitter's TRUNK button.

Starter Kill / Anti-Grind

Prevents the vehicle from being started without disarming the system and stops the starter from re-engaging.

Engine Run Time

Multi-car Operation

Troubleshooting Poor Transmitting Range Issues

Diagnostics – Parking Light Flash Table