In Repeater mode, Scan Repeater SSID whose password is known. Then configure the
wireless parameters as per your choice of SSID, Channel width, Encryption and Time
reboot if required.
Suggestion: Just in case if you don’t have any RJ 45 cable running to any room then In
Repeater mode you have to just power on the device and wirelessly can connect to
clients as well as available SSID (BSSID). No need of connecting physically LAN as well as
WAN port.
Fig 2.4.1 Repeater mode of AirONE APO300
To Next Page
Loading...