WI-FI
In Wi-Fi setting you can set the 2.4G, MAC ACL, Repeater, Wi-Fi Timer off and Advanced
settings.
2G Wi-Fi Settings:
Can set Multi SSID along with Basic SSID all other VAP 1, VAP 2, VAP 3 SSID can be set.
You can ON/OFF particular SSID with this setting.
Repeater Settings:
Repeater can be turn ON or OFF. Selecting scanning repeater SSID with lock BSSID and
password and encryption setting.
MAC ACL Settings:
Can allow and prohibit wireless clients based on MAC address.
Wi-Fi Timer Settings:
Wi-Fi Timer ON/ Off along with setting Time Frame.
Advanced Settings:
In Advanced setting can set Country Region, 2G Mode, Multicast Fast, Maximum wireless
clients for APO (Range 1-64), WLAN Partition, Short GI, Coverage Threshold and Transmit
Power
Note:
All italic config options are only available in WISP and Gateway mode only.
3.1 2G/5G Wi-Fi Setting
We can set 2.4G Wi-Fi with Basic Setting along with Virtual AP setting. You can enable or
disable Wi-Fi by
Wi-Fi Status: On mean SSID is available for wireless clients.
Wi-Fi Status: Off mean SSID not available.
Note: By default Basic Wi-Fi SSID “COMMANDO APO300 2.4G”
To Next Page
Loading...