Commodore 1581 - Initialize Command

1581 FILE COPY
VERSION 1.5.1
DESIGNED TO COPY : FILES FROM ONE DRIVE TO ANOTHER
REQUIRED EQUIPMENT: C128 OR C128D COMPUTER
(2) 1581 SINGLE DISK DRIVES
DATA DISKETTE
BLANK DISKETTE
40 COLUMN MONITOR OR TV SET
VERSION 1.5 DIAGNOSTIC DISKETTE
penn -- ---=
| THE DRIVES BEING USED MUST BE SET TO DIFFERENT DEVICE NUMBERS
a ---—
The File Copy Program is the same as the Universal Disk-File
Copy Program on the 1581 Test Demo Diskette.
The Program allows Disk Files from one drive to be copied to another
drive connected VIA the Serial Bus.
FILE COPY OPTIONS
CHANGE DEVICE NUMBER OPTION
* If (Y)es is selected ....
* Input the Original Device Number
* Input the New Device Number
* Turn Power OFF to all Drives except the one to be changed
* Press SPACE - Change Device Number
* If (N)o is selected ....
* Select Partition Options
PARTITION OPTIONS
THE PARTITION OPTIONS ARE VALID FOR THE 1581 ONLY AND
REQUIRES A PARTITION TO PREVIOUSLY HAVE BEEN CREATED
* If (Y)es is selected ....
* Enter Name of Partition to Open
* Select Read From or Write To Option
* If (R)ead is selected ....
* Selected Files will be Read from the Partition
* If (W)rite is selected ....
* Selected Files will be Written to the Partition
* Select File Transfer Options
* If (N)o is selected ....
* Select File Transfer Options
*»
Page 3-2