Commodore 1581 - Chapter 3: Basic 7.0 Commands; Error Checking

. 1581 FILE COPY
VERSION 1.5.1
FILE TRANSFER OPTIONS
* Input Copy From Unit (Source Drive Device Number)
* Data Diskette Must be Inserted in Source Drive
* Input Drive Number (Always [0] For 1581 or C128D)
* Input Copy To Unit (Destination Drive Device Number)
* Blank Diskette Must be Inserted in Destination Drive
* Write-Protect Tab Must be Closed
* Input Drive Number (Always [0] For 1581 or C128D)
NAME-SEARCH PATTERN OPTION
* If a File Name is Entered, only that file will be displayed for the
File Copy Selection Option
* If Selected Characters are entered followed by an [*] Symbol, only
files which begin with these characters will be displayed for the
File Copy Selection Option
* If RETURN is selected, all files will be displayed for the File Copy
Selection Option
FILE COPY SELECTION OPTION
The Selected Files will be displayed as ....
File Size File Name File Type
* Press (Y)es if you wish to copy the displayed file
* Press (N)o if you wish to skip the displayed file
* Press (¥)es followed by RETURN at any file to copy
all remaining files
* Press (N)o followed by RETURN at any file to skip
all remaining files
DESTINATION DISK NEW OPTION
If the Destination Diskette is Blank or the Information Contained is
no longer required, Select (Y)es here
If the Destination Diskette Contains Valid Data and files are to be
added, Select (N)o here
If (Y)es is selected ....
* Enter the Name and ID to be assigned to the Destination Diskette
* The Name is limited to (16) Characters, and may be either
Alpha or Numeric
* The ID Must be (2) Characters, and may be either
Alpha or Numeric but should not be a combination of the two
When the Format of the Destination Diskette is complete
* Blocks Free is displayed -- (Blocks Free Should = 1328)
* File Copy will begin
Page 3-3