Commodore Amiga - Page 12

On the right side of the main unit, you'll find two more connectors labeled
"1" and "2":
Before You Start
Before putting your Amiga together, be sure to read each instruction
carefully. While it's not difficult to assemble the Amiga, it is possible to
damage it if you don't follow the instructions.
When you attach any of the cables or insert anything into a connector,
remember: use a minimum of force. You can tell when a cable and
connector are properly mated when the end of the cable first slides into the
connector, then stops when it is in as far as it will go . Always start by
pushing gently on the end of a cable. If the cable doesn't slide inward,
check the cable and connector to make sure they match and that they're
properly oriented before applying more force .
Setting
Up the Amiga 2-3