Commodore Amiga - Chapter 5: AUDIO HARDWARE

• If you want the icon to include only a part of the image that's in the
frame, select Frame and Save. Next, "frame" within a rectangle
the part of the magnified view you want to include in the icon:
point to a place in the magnified view where you want the top left
corner of the rectangle, then click the Selection button. Move the
mouse to change the size of the rectangle. When you've framed
within the rectangle the part the image you want, click the Selection
button a second time to save the icon. (If you change your mind
about saving the icon after you've selected the top left corner, move
the Pointer outside
the magnified view and click a mouse button.)
If you decide not to save an icon after you've chosen Save Data, select
Cancel
the Save in the requester.
When you look on the Workbench for an icon you've saved, remember that
it doesn't replace the previous icon until the next time you open the drawer
that contains it.
Stopping the Icon Editor
When you are finished using the Icon Editor, close it by selecting the Close
Gadget in
the upper left corner of the Icon Editor window.
A-22
Appendices