205 object
not
found : A tool or project
that
the
Amiga
needs
to locate
is not
present
on the disk. This can
happen
if (1) you've
moved
a
tool to a different drawer,
then
try to
open
a project
created
with
that
tool (2) you've
renamed
either
the System or Utilities drawer
on the
Workbench
disk,
then
tried to
open
a project
created
with a
tool
that's
in the drawer, or (3)
the
disk containing a tool you
need
is
not
in a disk drive.
210
invalid
stream
component
name:
When
renaming
a tool, project,
drawer, or disk, you have used
an
invalid character.
213 disk
not
validated:
If
a disk light was
on
when you
removed
a disk
or reset the
Workbench,
the information on
the
disk
that
was in
that
drive may be unusable. This
error
may also occur if the disk
surface
has
been
damagetl.
214
disk write-protected:
You have asked the Amiga to
add
information to your disk when
the
protect
tab
is
in
the
protected
pOSItIon. (See pages
3-2
and
3-3
for information about
protect
tabs.) Either change
the
position of the protect tab or use a disk
whose
protect
tab
is
in the
unprotected
position.
218
device
not
mounted:
This
error
occurs when a tool
needs
a disk
that
is
not
currently in a disk drive.
221 disk full :
There
is not enough free storage
on
the disk to do what
you have
requested.
Try emptying the
Trashcan
(see page
4-17)
.
If
this
doesn't
work, you must
either
delete objects on
the
disk or
use a different disk.
222
file
is
protected
from deletion: A tool, project, or drawer
cannot
be
deleted
because
it
is
protected.
Select
the
icon for the object,
choose Info from the
Workbench
menu,
then
change its status to
DELETABLE.
225
not a DOS disk: Either the disk has
not
been
formatted or it is a
Kickstart disk. Use a different disk, or, if you wish to erase all
information currently
on
the disk, choose Initialize from the Disk
menu.
226
no
disk in drive: A tool expected to find a disk in a disk drive
that
wasn't
there.
Insert the disk
needed
by the tool
you're
using.
A-24
Appendices
To Next Page
Loading...
