Getting Back Preferences
If
you'd
like
to
get
back
the
Preferences
settings
that
came
with
the
original
Workbench
disk, select Reset All.
If
you'd
like
to
get
back
the
last
Preferences
settings you saved, select Last Saved.
Using and Saving Preferences
When
you're
done
with
Preferences,
select
one
of
the
gadgets at
the
lower
right of
the
window. Select Save
if
you want your settings to
take
effect now
and
each
time you start up
the
Workbench
with
the
Workbench
disk
you're
currently using. Selecting Save saves your settings on
the
Workbench
disk.
Select Use if you want your settings to
take
effect now,
but
you
don't
want
to save
the
settings
on
the
Workbench
disk for future use.
If
you
change
the
settings,
then
decide
you
don't
want
them
to
take
effect,
select
Cancel.
Because
each
Workbench
disk keeps its own
Preferences
settings,
different
people
can
save
their
own settings on
separate
Workbench
disks.
To
get
back
your settings, just set up the
Workbench
using
the
disk on which
you've
saved
them.
Input/Output Connectors
This
section lists
pin
assignments for several
input/output
connectors
on
the
Amiga.
The
information
in this section
is
highly
technical
and
is
intended
only for
those
expert
in
connecting
external
devices to
computers.
You do
not
need
this
information
if
you
use
a cable specifically
designed
for
use
with
the
Amiga
and
the
add-on
you want to
connect.
For
information
about
connectors
not
described
in this
section,
see
the
Amiga
Hardware
Manual.
7-10
Reference
To Next Page
Loading...
