Commodore PC - Page 184

1112 MS-DOS User's Reference
: U
Goto GotO
I
Purpose: M
Processes commands starting with the line after the specified
label.
Syntax:
goto label
Comments:
Goto lets you take commands from the batch file beginning with
the line after the label, where a label is defined as the characters
following goto. This label may include spaces, but not other
separators, such as semicolons or equal signs. If your batch file
does not contain the label, the batch file terminates. ( \
Note Any line in a batch file that starts with a colon (:) is
ignored during batch processing.
Example: ,
The following example sends the program processor to the label
named end only if no errors occur when you format the disk in
drive A: i \
:begin
echo off
format a: /s ivs j
if errorlevel 0 goto end
echo An error occurred during formatting.
:end
echo End of batch file.