Commodore PC - Break

Appendix B How to Configure Your System 247 |
n
n
n
n
n
Break Break
n
n
n
Purpose:
Sets control-c check.
Syntax:
break=[ON]
or
break=[OFF]
Comments:
Depending on the program you are running, you may use
control-c to stop an activity (for example, to stop sorting a file).
(***} Normally, ms-dos checks to see whether you have pressed
control-c only while it is reading from the keyboard or writing
to the screen or printer. Therefore, setting break to ON extends
x-n control-c checking to other functions, such as disk reading and
' writing.
Example:
To turn off control-c checking, put the following line in your Setting and canceling
config.sys file: CONTROL-C checking
break=off