Commodore PC - Page 354

1282 Appendix E MS-DOS Message Directory
You should use FC if you want to compare the files on the
disks. If you want to copy the disk, you can use copy or xcopy,
or reformat the target disk so that it's the same type as the
source disk, or use a disk of the same type.
Duplicate file name
[Rename]
■ You tried to rename a file to a filename that already exists, or
the name you specified could not be found.
ECHO is off (or on)
[MS-DOS]
■ This message tells you the current status of Echo.
End of input file
[Edlin]
■ The entire file was read into memory. If the file was read in
sections, this message indicates that the last section of the file U
is in memory.
Enter current Volume Label for drive x: i)
[Format]
■ Format asks you to enter the current volume label for verifica
tion before it formats the hard disk in the specified drive.
If you do not know what the volume label is, press control-c
to abort this command, and give the vol command for the
specified drive. Then give the format command again. , ,
Enter new date:
[Date]
■ You must respond to this prompt when you start msdos, or [)
when you use the Date command.
Enter the date in a mm-dd-yy format, or press the return key
to accept the current date. / \
Enter new time:
[Time]
■ You must respond to this prompt when you start msdos.
Enter the time in the hh.mm format, or press the return key
to accept the current time.
Entry error
[Edlin]
■ The last command you typed contained a syntax error.
Retype the command with the correct syntax and press the
return key.
u
U