Commodore PC - Page 370

1298 Appendix E MS-DOS Message Directory
No COM: ports w
[Mode]
■ Your computer does not have an asynchronous communica- / j
tions (serial) port. ^—^
No files adlded (or replaced)
[Replace] \^J
■ The Replace command did not add or replace any files.
No files found filename . \
[Replace] ^-^
■ Replace could not find matching source or target files.
No free file handles. \^J
Cannot start COMMAND.COM, exiting
[MS-DOS]
■ Restart MS-DOS. {^J
If this message persists, increase the files command value in the
configsys file.
Non-DOS disk error reading (or writing) drive x: w
[MS-DOS]
■ This is a device error. See Appendix D, 'Disk and Device
Errors." K^J
Non-system disk or disk error
Replace and strike any key when ready M
[Format][Sys] ^^
■ Replace the disk with the proper disk and press any
alphanumeric key to continue. -. ,
No paper error writing device dev
[MS-DOS]
■ This is a device error. See Appendix D, "Disk and Device \^J
Errors."
No path .
[Path] \J
■ You typed Path and pressed the return key to find out what
your search path is, but you didn't set a command search
path. K^J
No room for system on destination disk
ys] ( j
There is not enough room for the system files on the target ^-^
disk
Delete some files to make room for the system files or use ,
another disk. You may need to reformat the disk to put the ^—^
system on it.