Commodore Plus 4 - Page 189

-
■■:
32
33
34
SYNTAX ERROR
(invalid command]
SYNTAX ERROR
(invalid command)
SYNTAX ERROR
(invalid file name)
SYNTAX ERROR
(no file given)
-
~
50
~
51
SYNTAX ERROR
(invalid command)
by an illegal number of file names,
or patterns are illegally used. For
example, two file names may
appear on the left side o( the
COPY command.
The DOS Goes not recognize the
command- The command must
start in the first position.
The command senl is longer than
58 characters.
Pattern matching is invalidly used
in the OPEN or SAVE command.
The file name was left out of a
command or the DOS does not
recognize it as such. Typically,
a colon(:} has been left out of
the command.
This error may result if the com
mand rent to command channel
(secondary address 15) is unrec
ognized by the DOS.
RECORD NOT PRESENT Result of disk reading past the
last record through INPUT#. or
GET# commands. This message
will also occur after positioning to
a record beyond end of file in a
relative file. If the intent is to ex
pand the file by adding the new
record (with a PRINT# com
mand), the error message may be
ignored. INPUT or GET should not
be attempted after this error is de
tected without first repositioning.
OVERFLOW IN RECORD PRINT# statement exceeds
record boundary. Information is
truncated. Since the carriage re-
180