CommScope SYSTIMAX MGS Series - Page 3

www.commscope.com
860344274
Issue 9, October 2019
Page 3 of 5
3. To place conductors, hold the pair down on the
termination position and bend it for easy grasp as
shown above. Then untwist the pair in a counter-
clockwise direction enough to open it up.
4. Push conductors down into slot
positions (check color codes).
Maintain pair twist up to the
opening for the slots.
Orange pair
Blue pair
Green pair
Brown pair
Ensure that front pairs
are tightly routed
5. (
T568B wiring shown) On the Direct cable end, place Orange and Blue pairs first, then place Gr
een and
B
rown pairs.
Orange pair
Blue pair
Green pair
Brown pair
Ensure that front pairs
are tightly routed
6. (T568B wiring shown) On the Reverse cable end, pull Green and Brown pairs back, eliminate the twist,
and
pul
l them tightly into place. Then route Orange and Blue pairs to the front positions.