CommScope SYSTIMAX MGS Series - Conductor Seating and Cutting; Module Removal

860344274
Instruction Sheet
www.commscope.com
Page 4 of 5
Note: For T568A Wiring -
On each cable end, one of the two pairs fed in through the holes is pulled back for the rear positions. Check
label color codes.
Conductor Seating and Cutting
Impact tool on HI setting
with M110 cutting blade
Hand puck
Pliers
Trim pairs
flush
Fine edge
cutters
1. Use impact tool on HI setting with M110
cutting blade
to punch conductors
straight down into slots. When using the
impact t
ool, the hand puck is
recommended.
Or
2. Use pliers with wire cap to seat
conductors. Use fine edge cutters t
o
t
rim conductors flush to the modul
e
body
.
Module Removal
1. To remove a module for inspection or
repair, insert prongs of removal tool into
openings at sides of module and press
firmly.
Or
The module wiring cap can also be used to
remove a module. Insert prongs of cap into
openings at sides of module and press
firmly.
2. The module can then be removed from t
he
bac
k.
Removal tool