I
I
I
I
Warranty .......................................................... Page 2
Rules for Safe Operation ...................................... Page 3
Safety Symbols .................................................. Page 7
Unpacking ........................................................ Page 8
Description ....................................................... Page 8
Operation .......................................................... Page 9
Maintenance ...................................................... Page 15
Troubleshooting .................................................. Page 17
Accessories ....................................................... Page 17
Service Numbers ................................................ Back Cover
ONE FULLYEAR WARRANTY ON COMPANION
ELECTRIC DRILL
If this Companion Electric Drill fails due to a defect in material or
workmanship within one year from the date of purchase, RETURN ITTO
THE NEAREST SEARS STORE IN THE UNITED STATES, and Sears will
replace it, free of charge.
This warranty is void if this tool is used for commercial or rental purposes,
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state,
Sears, Roebuck and Co,, Dept.817WA, Hoffman Estates, IL 60179
SAVE THESE INSTRUCTIONS!
READ ALL INSTRUCTIONS!
WORK AREA SAFETY
1. ALWAYS keep your work area clean and well lit. Cluttered benches and dark areas
invite accidents.
2. DO NOT operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases, or dust. Power tools create sparks which may ignite the
dust or fumes.
3. ALWAYS keep bystanders, children and visitors away while operating a power tool.
Distractions can cause you to lose control.
ELECTRICAL SAFETY
1. Double insulated tools are equipped with a polarized plug (one blade is wider than
the other.) This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install a polarized outlet. Do not change the plug in any way.
2. Double insulation r_leliminates the need for the three-wire grounded power cord
and grounded power supply system. Applicable only to Class II (double insulated)
tools.
3. Before plugging in the tool, BE SURE that the outlet voltage supplied is within the
voltage marked on the tool's data plate. DO NOT use "AC only" rated tools with a
DC power supply.
4. ALWAYS avoid body contact with grounded surfaces, such as pipes, radiators,
ranges and refrigerators. There is an increased risk of electric shock if your body
is grounded.
5. If operating the power tool in damp locations is unavoidable, ALWAYS use a
Ground Fault Circuit Interrupter to supply power to your tool. ALWAYS wear
electrician's rubber gloves and footwear in damp conditions.
6. DO NOT expose power tools to rain or wet conditions. Water entering a power tool
will increase the risk of electric shock.
7. DO NOT abuse the cord. NEVER use the cord to carry the tools or pull the plug
from the outlet. Keep cord away from heat, oil, sharp edges or moving parts.
Replace damaged cords immediately. Damaged cords increase the risk of electric
shock.
8. When operating a power tool outside, ALWAYS use an outdoor extension cord
marked "W-A" or "W". These cords are rated for outdoor use and reduce the risk
of electric shock.
NOTE: The extension cord must have adequate wire size AWG (American Wire
Gauge) for safe, efficient use. Smaller gauge wires have greater capacity (16 gauge
wire has more capacity than 18 gauge wire).
To Next Page
Loading...