C-14
Agency Regulatory Notices
Writer: Shelly Ficalora Saved by: J Abercrombie Saved date: 01/09/98 9:00 AM
Part Number: 266667-001 File name: 17Appc.doc
■
This apparatus has been approved for the following facilities:
❏
Simple modem
❏
Facsimile
❏
Automatic call initiation
❑
Detection of initial proceed indication
❑
Automatic dialing
❏
Tone detection of busy tone, dial tone, or number
unobtainable tone
❏
Auto clear from the call origination end
❏
Loop disconnect (pulse) dialing
❏
Multifrequency (tone) dialing
Any other usage will invalidate the approval of the apparatus if,
as a result, it ceases to conform to the standards against which
approval was granted.
All apparatus connected to this modem and, thereby, connected
directly or indirectly to the British Telecom Public Switched
Telephone Network, must be approved apparatus as defined in
Section 16 of the British Telecommunications Act of 1981.
Although this equipment can use either loop disconnect or DTMF
signaling, only the performance of the DTMF signaling is subject
to regulatory requirements for correct operation. It is therefore
strongly recommended that the equipment be set to use DTMF
signaling for access to public or private emergency services.
DTMF signaling also provides faster call setup.
CAUTION:
The Series 2930A may not be used on extension wiring
that makes use of plug pins1&6.Ifindoubt, advice must be
obtained from a competent telecommunications engineer.
This device is intended for auto-answering of incoming calls.
Under normal conditions, callers will be accustomed to calls
being answered within 10 seconds, and a majority of callers will
abandon calls that are not answered within 45 seconds.
There are several options available for auto-answering operation.
The default setting is for two incoming rings. This is the
recommended setting for normal operation by most computer and
handheld PC users.
To Next Page
Loading...
