4-14
Using Power
Writer: Shelly Ficalora Saved by: Rebecca Wiggins Saved date: 01/08/98 4:04 PM
Part Number: 266667-001 File name: 08Ch04.doc
Performing a Full Reset
A full reset restarts your device and removes all information that
was stored in memory, such as your data files and your system
settings.
NOTE:
If you saved your data using one of the backup and restore
utilities provided with your C-Series, it is possible to restore your
saved data after performing a full reset. For more on using the
backup and restore utilities, see Chapter 8, “Using Compaq
Software.”
To perform a full reset, follow these steps:
1. If using external power, disconnect the device from the AC
Adapter.
2. Close the lid and turn over the device.
3. Remove both the main and backup batteries.
4. Wait at least 5 minutes, then replace the batteries.
5. Turn over the device, open it, and press the power button to
restart the handheld PC.
6. Run through the Setup Wizard again to reestablish your
system and calibration settings.
NOTE:
If you previously saved data using the Compaq Flash
Memory Manager backup utility, you will be prompted to restore
your saved data. Select ‘Yes’ if you wish to do so.
To Next Page
Loading...
