6 User’s Guide
product performance standards set by government agencies
as a Class 1 laser product. It does not emit hazardous light;
the beam is totally enclosed during all modes of customer
operation and maintenance.
This system is classified as a
CLASS 1 LASER PRODUCT. This
label is located on the outside of
your system. A similar label also
appears on the internal CD-ROM
installed in your system.
Care and Maintenance Guidelines
To enhance the performance and extend the life of your monitor,
use the following guidelines:
■ Do not open your monitor cabinet or attempt to service this
product yourself. Adjust only those controls that are covered
in the operating instructions. If your monitor is not operating
properly or has been dropped or damaged, contact your
Compaq authorized dealer, reseller, or service provider.
■ Adjust only those controls that are discussed in the operating
instructions.
■ Place your monitor at least 3 inches (76 mm) away from
walls or other enclosures.
■ Use only a power source and connection appropriate for this
monitor, as indicated on the label/back plate of the monitor.
■ Be sure the total ampere rating of the products connected to
the outlet does not exceed the current rating of the electrical
outlet, and the total ampere rating of the products connected
to the cord does not exceed the rating of the cord. Look on the
power label to determine the ampere rating (AMPS or A) for
each device.
306848-001.book Page 6 Wednesday, July 31, 2002 7:03 PM
To Next Page
Loading...
Need help?
General
