3
This information is for customers or field service personnel who are upgrading to
either an AlphaServer ES40 667 or 833MHz system.
If you have purchased an additional 667 or 833 MHz SMP CPU for a system, you do
not need to read further. Install the add-on as described in Chapter 5 of the
AlphaServer ES40 Owner's Guide.
NOTE: The upgrade requires a minimum Rev E0* system motherboard (54-25385-
01). If the board in your system is Rev D0* or lower, call your local Field Service
office or 1-800-OK-COMPAQ (1-800-652-6672) and inquire about FC0# 00-ES40 F002
for the ES40 system. Under this Field Change Order, Field Service will replace
your system motherboard with Rev E0* or higher at no cost to you. Follow the
procedure on the next page to determine if the motherboard must be replaced. The
system might also contain a motherboard (54-25385-02) of which the minimum
revision is A01. If this is the case, then there is no need to replace the motherboard.
Upgrade Kit
1. The KN610-Bx upgrade kits contain the following components:
Component Part Number Quantity
CPU card 54-30362-01 1
Alpha Systems Firmware CD QB-5VUAA-SA 1
Upgrade documentation EK-KN610-UP 1
Software license (optional – depends
on variation)
2. The KN610-Cx upgrade kits contain the following components:
Component Part Number Quantity
CPU card 54-30362-B3 1
Alpha Systems Firmware CD QB-5VUAA-SA 1
Upgrade documentation EK-KN610-UP 1
Software license (optional – depends
on variation)
Installation Tools
The upgrade requires the following tools:
• Phillips #2 screwdriver (a magnetic screwdriver is recommended)
• Allenwrench(3mm)
• Anti-static wrist strap
To Next Page
Loading...
Need help?
General
