Installing a System into a Cabinet 9
Front
1.
Starting at the top marked hole, put two hex screws
➊ through the cabinet
rail and the slide bracket
➋. Fasten with a 5-hole nut bar ➌ using the
second and third holes from the top.
2.
Insert two cap screws
➍ through the slide bracket and the cabinet rail. Fit
the perforations of a 2-hole, 2-perforation nut bar
➎ into the holes in the
cabinet rail and fasten.
3.
Repeat the procedure for the other rail.
Back
1.
Starting at the top marked hole, put two hex screws
➊ through the cabinet
rail and the slide bracket
➋. Fasten with an 8-hole nut bar ➏ using the top
two holes.
2.
Insert two cap screws
➍ through the slide bracket and the cabinet rail. Fit
the perforations of a 2-hole, 2-perforation nut bar
➎ into the holes in the
cabinet rail and fasten.
3.
Repeat the procedure for the other rail.
To Next Page
Loading...
Need help?
General
