Installing a System into a Cabinet 11
The sliding segment of the slide has an access hole
➊ that provides access to
three mounting holes in the stationary segment. You use two of the mounting
holes.
Front
1.
Insert a cap screw through the access hole
➊ and the first (forward-most)
mounting hole
➋ in the slide and through the hole ➌ in the slide bracket.
Fasten with one two-hole nut bar
➍ and tighten.
2.
Align the access hole with the second mounting hole
➎ in the slide.
3.
Insert a cap screw through the access hole and the second hole
➎ in the
slide and through a slot
➏ in the slide bracket. Fasten into the nut bar and
tighten.
Back
1.
Insert a screw through the two holes
➐ in the stationary segment of the
slide and through a slot in the slide bracket. Attach to a two-hole
nut bar
➍.
Repeat the entire procedure for the other slide.
To Next Page
Loading...
